Irontech Reparaturset

Das Reparaturset von Irontech Doll eignet sich zur Reparatur von Verletzungen von Liebespuppen.

Dies ist ein komplettes Sexpuppen-Reparaturset für Silikonprodukte, das hochwertige Reparaturkleber, AB-Gel zum Umformen, Fleckenentferner, Reinigungsöl und wichtige Werkzeuge wie Spritzen und Wattestäbchen enthält. Perfekt, um Schäden, Verformungen und Flecken präzise und einfach zu beheben.

Repair Glue - Silicone 30ml

* Clean the damaged area thoroughly, ensuring it is free of debris.
* Use an appropriate tool or a cotton swab to apply glue to the damaged spot.
* Carefully wipe away excess glue from the surface, not disturbing the applied glue layer.
* Let it sit for 6–8 hours, then check if the damage has been repaired.

Nail Glue - For Silicone 10ml

* Clean the area where the nail will be applied, ensuring it is clean and dry.

* Remove the cap from the nail glue.
* Carefully apply glue to the nail application area, ensuring moderate glue usage.
* Attach the nail and press lightly for 30 seconds.

Note: Avoid excessive pressure on the nail and fingers to prevent tension between the nail and the silicone, which may cause detachment.

AB Gel - For Gel Breasts or Buttocks Deformation 100ml

* Prepare an empty cup, cleaning oil, and a syringe set.
* Note: The needle is very sharp; handle it carefully to avoid injury.
* Pinch the nipple with your fingers and slowly insert the needle deep into the nipple.
* After insertion, gently use the needle to separate the gel section from the skin to create a cavity, ensuring a smooth injection process.
* Repeat steps 2 and 3 to create a cavity in the other breast.
* Firmly connect the syringe needle to the tube to prevent detachment.
* Use a cup to thoroughly mix Gel A and Gel B in a 1:1 ratio.
* Note: The gel must be stirred evenly and injected promptly after mixing, as it will solidify quickly.
* Fill the syringe with the mixed gel, connect it to the needle using the tube, and begin the injection, holding the connection firmly.
* Note: Adjust the needle position during the injection to ensure even gel distribution.
* After the injection, remove the needle and clean the syringe parts with cleaning oil to prevent clogging.

Stain Remover 15g

* Use cleaning oil to clean the stained area thoroughly.
* Evenly apply the stain remover to the stained area.
* Let it sit for 8 hours, during which most stains will be removed.
* Clean the surface again with cleaning oil.

Note: The effectiveness of the stain remover may vary depending on the type of stain. Multiple applications may be required based on the actual situation.

Cleaning Oil 100ml

* Can be applied directly to stains for wiping clean, or a cleaning cloth soaked in cleaning oil can be used to wipe the stains.
* Note: Keep the bottle sealed to prevent the cleaning oil from evaporating.

Other included accessories

* Syringe Set
* Cotton Swabs
* Cleaning Cloth
* Repair Kit Instructions